*Clicking on an article below will expand the article for reading. Clicking the article again will collapse it. You can also use the section index above to automatically expand an article and scroll to the beginning of it.
Required Tools: Coming Soon
Step 1: Park the car on level ground. Be sure there is enough room to safely work.
Step 2: Make sure the e-brake is engaged and that the car is in gear.
Step 3: Locate the correct jacking point according to what area of the car you are going to be working on.
Step 4: Lift the car enough so that the wheel is off the ground or so that there is enough room under the car to work.
Step 5: Place stand(s) if needed. If you aren't going to use stands, place a safety stand near the jack in case the jack fails.
Required Tools: Coming Soon
This article is currently being written and will be available soon.
Required Tools: Coming Soon
Step 1: Remove the four bolts that secure the front jack up plate to the cross member using a 14mm socket. You are required to hold down the nuts on the cross member using a 14mm socket while you loosen the two front bolts.
Step 2: Remove the front jack up plate.
Required Tools: Coming Soon
This article is currently being written and will be available soon.
Required Tools: Coming Soon
Note: Repeat all steps on both sides.
Step 1: SEDAN Remove the nut that secures the end link to the control arm by inserting a ?mm alan wrench to hold it center while you remove the nut using a 12mm wrench.
Step 2: Pull out the end link from the control arm.
Step 3: Remove the two bolts that secure the stabilizer to the cross member using a 12mm socket.
Step 4: Remove the front sway bar.
Required Tools: Coming Soon
Note: Repeat all steps on both sides.
Step 1: Install the sway bar and secure it to the cross member by tightening down the two bolts that secure the brackets using a 12mm socket. Tighten the bolts to 18.1 foot pounds of torque using your torque wrench.
Step 2: Wagon Install the front end link to the control arm using a ? alan wrench to hold the stud while you tighten the nut with a 12mm wrench. Tighten the nut to 33.0 foot pounds of torque using a torque wrench.
Required Tools: Coming Soon
This article is currently being written and will be available soon.
Required Tools: Coming Soon
Step 1: Install the front jack up plate. Tighten the two front bolts using a 14mm socket while you hold the nuts that secure it to the cross member using a 14mm wrench. Tighten the bolts to 52.0 foot pounds of torque using a torque wrench.
Step 2: Tighten the two rear bolts that secure the plate to the cross member using a 14mm socket. Tighten the bolts to 52.0 foot pounds of torque using a torque wrench.
Required Tools: Coming Soon
This article is currently being written and will be available soon.
Required Tools: Coming Soon
Step 1: Make sure there is nothing under your car (bolts, tools, friends, etc.)
Step 2: If the car is supported on jack stands, lift the jack until there is no load on the stand. Remove the stand(s).
Step 3: If the car is supported by the jack, remove the safety stand.
Step 4: Once again make sure that it is safe to lower the car.
Step 5: Lower the car and remove the jack.
Click here to discuss this guide in our forums!
