Part 1: Intercooler Removal

Time: 10 Minutes   Difficulty: 3/10

Step 1: Disconnect the three air hoses from the intercooler.


Step 2: Separate the by pass valve from the intercooler by removing the two bolts using a 12mm socket.


Step 3: Remove the two bolts that secure the intercooler to the brackets using a 12mm socket.


Step 4: Loosen the clamp that secures the intercooler tube to the turbo using a 10mm socket.


Step 5: Loosen the clamp that secures the intercooler to the throttle body using a flat head screw driver.


Step 6: Lift up on the back of the intercooler and remove it.

Click here for tips, tricks and discussion of this article.

Part 2: Lifting Car

Time: 8 Minutes   Difficulty: 4/10

Step 1: Park the car on level ground. Be sure there is enough room to safely work.

Step 2: Make sure the e-brake is engaged and that the car is in gear.

Step 3: Locate the correct jacking point according to what area of the car you are going to be working on.

Step 4: Lift the car enough so that the wheel is off the ground or so that there is enough room under the car to work.

Step 5: Place stand(s) if needed. If you aren't going to use stands, place a safety stand near the jack in case the jack fails.

Click here for tips, tricks and discussion of this article.

Part 3: Transmission Oil Draining

Time: 10 Minutes   Difficulty: 3/10

This article is currently being written and will be available soon.

If you'd like to add to the required tools, difficulty, approximate time, steps, or pictures for this article please visit the article's forum page or visit the content submission forum.

Part 4: Lowering Car

Time: 8 Minutes   Difficulty: 4/10

Step 1: Make sure there is nothing under your car (bolts, tools, friends, etc.)

Step 2: If the car is supported on jack stands, lift the jack until there is no load on the stand. Remove the stand(s).

Step 3: If the car is supported by the jack, remove the safety stand.

Step 4: Once again make sure that it is safe to lower the car.

Step 5: Lower the car and remove the jack.

Click here for tips, tricks and discussion of this article.

Part 5: Transmission Oil Filling

Time: 10 Minutes   Difficulty: 3/10

This article is currently being written and will be available soon.

If you'd like to add to the required tools, difficulty, approximate time, steps, or pictures for this article please visit the article's forum page or visit the content submission forum.

Part 6: Intercooler Install

Time: 15 Minutes   Difficulty: 5/10

Step 1: Install the top mount intercooler. Be sure that the two throttle body clamps and the intercooler turbo pipe clamps are already on the hoses.


Step 2: Tighten the clamp that secures the intercooler air duct to the turbo using a 10mm socket.


Step 3: Tighten the clamp that secures the intercooler to the throttle body by tightening the clamps using a 8mm socket or a flat head screw driver.


Step 4: Secure the intercooler to the brackets by tightening the two bolts using a 12mm socket. Tighten the bolts to 11.7 foot pounds of torque using a torque wrench.


Step 5: Place a new gasket between the bypass valve and intercooler. Secure the by pass valve to the intercooler by tightening the two bolts using a 12mm socket. Tighten the bolts to 11.7 foot pounds of torque using a torque wrench.


Step 6: Connect the three air hoses to the intercooler.

Click here for tips, tricks and discussion of this article.